IC Glow-In-The-Dark Ink - 5 Gallon

$899.99   $180/gal

SKU: # IKPL-108LF5
$899.99   $180/gal
Subscribe to this item » Learn More

Subscription Frequency

Phosphorescent ink can add a highlight to your design and keep it seen even in the dark. This ink can be used right out of the container or for cold peel transfers. A white shirt or underbase is recommended for this item to give the best effect. This ink is not a low bleed ink and should be tested prior to printing. Give your customers a unique glowing print with International Coatings Glow in the Dark ink.

Screens must be coated with a plastisol or hybrid emulsion. Post-hardening the stencil is recommended for long print runs. If using with a pigment system, mix in pigment at the desired shade or level. 1-10% is normal for standard pigments and up to 20% for fluorescent pigments. Inks may be thinned with Curable Reducer, if a lower viscosity is required, up to 10% max.


Print wet-on-wet without flash curing. Degree of color/wash fastness is dependent on proper curing.


36 to 305t/in. The mesh count being used will determine how much squeegee pressure should be used.


60-80 Durometer. Can also use 70/90/70 triple durometer squeegees. Typically heavy squeegee pressure is preferred.


Use RXP, HiFi or any standard plastisol emulsion.

Cure Instructions

325°F through the entire ink film. Test dryer temperatures before a production run. Wash test printed product prior to beginning production run.

Clean Up

Plastisol screen wash such as Citra Paste. You may use mineral spirits sparingly, as it my break down screen adhesive.


H (1) F (1) R (0) P (B)


Recommend storage at 65-90°F. Avoid storage in sunlight and moist, humid air.

No reviews available

Be the first to Write a Review