IC 7600 Low Build Black Plastisol Ink - Gallon

$44.99


SKU: # IKPL-7617LF-G
$44.99
» View Availability and Shipping Map
The 7600 series ink provides the maximum performance for high speed hot automatic shops. If you're looking at a Diamondback or other M&R auto, or currently running an auto, this is the ink you'll for low buildup and printing efficiency!



  • Ready for use, High Performance plastisol formulated for Ultra High speed automatic printing.
  • Very creamy and short bodied, with low tack and for ease of printing, a greatly improved shear.
  • Well suited for high definition and resolution, fine detail and halftone printing.
  • Faster production speeds with less pressure. Can be printed through finer mesh counts for faster production speeds with less pressure.
Application & Storage Information:



RECOMMENDED FABRICS

Light colored 100% cotton or cotton/polyester blends. Use an underbase for printing dark fabrics. Looking for an ink to print directly on dark? Try RyOpaque (also good for auto's).



INK APPLICATION

Colors should be printed without any modifications. If thinning is required, use 1099LF LB Lo-Bleed Reducer (1% to 3% by weight).



SCREEN MESH & EMULSION

1 10 to 305 t/in 43 to 120 t/cm Monofilament

Any direct or indirect lacquer resistant emulsion. Use 35 to 70 micron capillary film for best results.



SQUEEGEE

60-70 Durometer: Sharp Edge

60-90-60 or 70-90-70 Triple Durometer: Sharp Edge



CURE TEMPERATURE

325℃ (163℃) Entire ink film. Test dryer temperatures and wash test printed product before and during a production run.



CLEAN-UP

Environmentally friendly plastisol screen wash.



SPOT FLASHING:

The 7600 inks will spot dry, with very low after flash tack, in 3 to 8 seconds depending on the spot dryer used. Too much heat / time may cause the ink to become sticky after flashing. Adjust flash unit accordingly. When spot drying, the ink should be just dry to the touch, with no lift off, but not totally fused. Totally fusing any of the flashed colors may cause inter-coat adhesion problems with the inks printed on top of the flashed ink. Final curing I fusing will occur in the dryer.



IMPORTANT INFORMATION:



  1. Use an underbase print when printing 7600 inks onto dark fabrics. Use 771LF, 774LF, 7031LF or 7034LF white as an underbase ink. To achieve a softer hand and faster production speeds, print underbase ink through finer mesh counts 230 to 305 t/in or 90 to 120 t/cm.
  2. The 7600 inks are low bleed inks, not non-bleed inks. On some types of fabric, bleeding or dye migration may occur. Always test print the fabric to be printed before beginning production. Bleeding or dye migration may not occur right away.
  3. Excessive squeegee pressure will drive the 7600 inks through the fabric being printed. Adjust squeegee pressure, angle and off-contact to insure proper shear and lay down of printed ink. Proper settings of squeegee, flood bar and off-contact will improve performance, improve screen life and squeegee durability.
  4. Adding too much reducer or other additives to the 7600 inks may cause curing/fusing or increased dye migration problems.
  5. The 7600 inks are easy to print when compared to other inks and can be printed through finer mesh counts. This means less ink usage and faster production times, a real money saver. Using finer mesh counts also means a softer hand of the finished product.

No reviews available

Be the first to Write a Review