Ryo Screen Blockout - Quart
Ryo Screen Blockout is a medium viscosity, water soluble blockout designed to fill the open areas of the screen not covered by the emulsion. This blockout was built to withstand squeegee abrasion and long print runs.
- When the screen is dry and free of contaminants, pour Ryo Screen Blockout on the print side of the screen. Spread over the open areas of the screen until completely filled.
- Touch up all defects, including heavy blobs which tend to dry the outside and pop off or smear during printing. Where very fine meshes are used, you may reduce the viscosity by adding a little water.
- To remove, flush Blockout with water.