Ryonet Discharge Agent
To activate discharge, mix agent into discharge at about 4-6% of the discharge binder/base. Discharge Agent has an unpleasant odor and should be handled carefully in its crystal form then blended into the ink by a properly trained employee. Always blend the agent slowly until it is well mixed in the ink to prevent dust, the agent is relatively safe once in solution.
We recommend using a gram scale for optimal mixing performance. *Not compatible with Matsui pigment must use Ryonet Discharge Base
Screens must be coated with a water based or hybrid emulsion. Post-hardening the stencil is recommended for long print runs. If using with a pigment system, mix in pigment at the desired shade or level. 1-10% is normal for standard pigments and up to 20% for fluorescent pigments.
Print wet-on-wet without flash curing. Degree of color/wash fastness is dependent on proper curing. Add Water Base and Discharge Reducer/Retarder up to 5% to prevent drying in the screen.
110 to 305t/inThe mesh count being used will determine how much squeegee pressure should be used.
60-80 Durometer. Can also use 70/90/70 triple durometer squeegees. Typically heavy squeegee pressure is preferred.
Use WBP or any standard water based emulsion.
The printed fabric should be cured for a minimum of 90 seconds at 320 degrees F. Ideally, the printed fabric should be cured for 2-3 minutes at 340-350 degrees F.
General wash-up, on ink that has not dried up, can be done with water. EnviroSolv is recommended as an on-press cleaner and screen opener.
H (1) F (2) R (0)
Store away from ignition sources and in a cool dry area.