IC 7503 UltraMix Yellow Plastisol Ink - Gallon

$79.99


SKU: # IKPL-7503LF-G
$79.99
The UltraMix 7500 Color System is economically priced and easy to use, UltraMix7500 inks offer faster wet-on-wet production speeds with less pressure and extremely low ink build-up. The color matching system consists of 15 intermixable colors that enable printers to simulate PANTONE colors on white and dark (with white underlay) fabrics.
Application & Storage Information

RECOMMENDED FABRICS: Light colored 100% cotton or cotton/polyester blends. Use an underbase for printing dark fabrics.



INK APPLICATION: Colors should be printed without any modifications. If thinning is required, use IC curable reducer (1% to 5% by volume).



SCREEN MESH AND EMULSION: 110 to 305 any direct or indirect lacquer resistant emulsion. Use 35 to 70 micron capillary film for best results.



SQUEEGEE: 60-70 durometer: sharp edge 60-90-60 or 70-90-70 triple durometer: sharp edge.



CURE TEMPERATURE: 325F (163C) entire ink film. Test dryer temperatures and wash test printed product before and during a production run.



CLEAN-UP: Screen wash 147 or any environmentally friendly plastisol screen wash.



STORAGE OF INK CONTAINERS: Recommend storage at 65F to 90F (18C to 32C). Avoid storage in direct sunlight. Keep containers well sealed.



SPOT FLASHING The UltraMix 7500 inks will spot dry, with very low after flash tack, in 3 to 8 seconds depending on the spot dryer used. Too much heat  and/or time may cause the ink to become sticky after flashing. Adjust flash unit accordingly. When spot drying, the ink should be just dry to the touch, with no lift off, but not totally fused. Totally fusing any of the flashed colors may cause inter-coat adhesion problems with the inks printed on top of the flashed ink. Final curing/fusing will occur in the dryer.

Compare to: Rutland M3 Yellow

No reviews available

Be the first to Write a Review