IC Quick Transfer Additive for Plastisol Ink - 5 Gallon

$359.99   $72.00/gal


SKU: # IKPL-500LF-5G
$359.99   $72.00/gal
The 500 Quick-Trans Additive will convert any of International Coatings' Multipurpose or 700 Series plastisol inks to hot split or hot peel transfer inks.
Preparation

Screens must be coated with a plastisol or hybrid emulsion. Post-hardening the stencil is recommended for long print runs. If using with a pigment system, mix in pigment at the desired shade or level. 1-10% is normal for standard pigments and up to 20% for fluorescent pigments. Inks may be thinned with Curable Reducer, if a lower viscosity is required, up to 10% max.



Application

Print wet-on-wet without flash curing. Degree of color/wash fastness is dependent on proper curing.



Mesh

36 to 305t/in. The mesh count being used will determine how much squeegee pressure should be used.



Squeegee

60-80 Durometer. Can also use 70/90/70 triple durometer squeegees. Typically heavy squeegee pressure is preferred.



Emulsion

Use RXP, HiFi or any standard plastisol emulsion.



Cure Instructions

325°F through the entire ink film. Test dryer temperatures before a production run. Wash test printed product prior to beginning production run.



Clean Up

Plastisol screen wash such as Citra Paste. You may use mineral spirits sparingly, as it my break down screen adhesive.



HMIS

H (1) F (1) R (0) P (B)



Storage

Recommend storage at 65-90°F. Avoid storage in sunlight and moist, humid air.

No reviews available

Be the first to Write a Review