Welcome to the assembly instructions for the BASELAYR Screen Rack. In the following steps, we will guide you through the process of setting up your cart to ensure smooth and efficient screen printing operations. Watch the video, view the assembly instructions, and follow along to assemble your screen rack.
- 7/16” Wrench
- Large pliers or crescent wrench
- Phillips screwdriver
Attach the lower side cross bars to the uprights in the four mounting points shown below. Ensure that you are attaching the crossbar that has the threaded inserts at this step. The uprights can be installed on both the left- and right-hand sides.
Attach the upper side cross bars to the uprights in the four mounting points shown below. Ensure that you are attaching the crossbar that do not have threaded inserts at this step.
Attach the screen holding slats. It is recommended to install one slat at a time to ensure you have ample room to install hardware. Start the slat installation with a hand screwdriver. Hold the lock nut in place with your finger until it is snug and grabs the metal. Once the nut no longer moves freely, fully tighten the screws.
Repeat steps 1-3 for the opposite side panel.
Attach the upper, lower, front, and rear crossbars. This part is used in all four locations. The screen rack will have extra hole cutouts in the parts that can be used for attachments that are purchased separately.
NOTE: Not all holes are used during screen rack assembly.
Attach the lower support gussets with ¼” hardware. Install the swivel caster with spacer as shown. Fully tighten the caster with pliers or a crescent wrench to ensure the wheel does not loosen over time.