The Green Galaxy Water Based Printer's ink combo was specially designed to give you easy access to the two most commonly used inks in the screen printing industry. Green Galaxy's Comet White and Pitch Black packaged together, giving you the highest standard of water-based inks with only one purchase.
Kit Includes:
- 1 gallon Green Galaxy Comet White
- 1 gallon Green Galaxy Pitch Black
General Information:
Eco-friendly, ready-to-use water-based ink for printing on light or dark cotton and other non dye-migrating fabrics. Can be printed on dark polyester or dye migrating fabrics with the use of a compatible low cure catalyst.
Mesh Guidelines:
Can be used with any mesh between 110-305.
Stencil/Emulsion Guidelines:
We recommend using either a water resistant emulsion like Ryonet WBP or using an emulsion hardener like Ryonet Harden-X.
Mixing info:
This product can be mixed with transparent and covering ink from the AB series
Printing Instructions:
Load screen with plenty of Green Galaxy water-based ink. Flood screen prior to printing. The ink can be printed with a push or pull squeegee stroke. After printing, flood screen allowing ink to sit on top of image to avoid drying. If screen clogs or exhibits dry ink in the print, re-flood and aggressively print again, this should clear the screen. If it does not clear the screen, spray a small amount of warm water into the stuck areas of the screen and wipe out with a rag. If you are leaving your screen for an extended period of time be sure to leave your screen flooded completely. If your ink begins to scale over, spray with water to re-wet the ink. Green Galaxy water-based ink can be printed with other water-based inks and with plastisol inks.
Flashing Instructions:
For flashing, forced air flash is optimal. Flash until dry to the touch.
Curing Instructions:
Printed fabric should be cured for a minimum of 90 seconds at 360°F. Ideally, printed fabric should be cured for three minutes at 300–320°F.
Testing/Precautions:
After printing, perform a stretch test to ensure elasticity. It is always recommend to perform a wash test to ensure proper cure prior to going into production. You may also run abrasion testing to watch for flaking and test adhesion. Increase cure dwell time if testing fails
Clean Up:
Ink should be removed from screen as soon as printing is completed. General wash-up (on ink that has not dried) can be done with water, though using Enviro-Solve is much easier and recommended. For more aggressive cleaning or dried screens, use Enviro-Solve to dissolve ink and blast out areas of stuck ink with water pressure.
Storage info:
Keep container(s) tightly closed. Store in cool, well ventilated location that is locked.
General Safety Precautions:
Do not breathe vapors. Wear protective gloves. Do not eat, drink or smoke when using product. Wash hands thoroughly after handling. Dispose of this product in accordance with local, regional, national and international regulations as specified.
United States